Lancia Beta Forum

General Category => Off Topic => Topic started by: JohnFol on October 29, 2020, 05:33:35 PM



Title: "No Volt Release" switches
Post by: JohnFol on October 29, 2020, 05:33:35 PM
Afternoon all, when I kitted out the garage many moons ago I put a fused spur to the workbench and a big on/off switch mounted in the workbench. This in turn energised a couple of double sockets and a few hard wired devices such as bench grinder. The idea was I could hit 1 "kill" switch and the whole bench goes dead

Roll forward a few years and I'd like to replace the big on/off with a "No Volt Release" switch. They seem to be rated at 10A so energising a few sockets might be pushing it a bit. Chance of running over 10A is miniscule, but the whole point is safety. Not against buying more than 1, but any advice on higher rated switches?





Title: Re: "No Volt Release" switches
Post by: peteracs on October 29, 2020, 06:04:51 PM
Hi John

This one is rated to 16A. I would have thought that would be plenty of head room for a workbench given you would normally be using one piece of kit at a time?

https://www.ebay.co.uk/itm/Woodturning-Woodworking-No-Volt-Release-Switch-NVR-Stand-Alone-Switch-with-emer-/114347705243?_trksid=p2385738.m4383.l4275.c10 (https://www.ebay.co.uk/itm/Woodturning-Woodworking-No-Volt-Release-Switch-NVR-Stand-Alone-Switch-with-emer-/114347705243?_trksid=p2385738.m4383.l4275.c10)

Peter


Title: Re: "No Volt Release" switches
Post by: JohnFol on October 29, 2020, 06:29:28 PM
I'd hope so! I also have 2 trickle chargers permanently plugged in, and of course the amp/receiver so it does creep up.

Link is great and good to know such a gadget exists.