|
Title: No pressure after MC rebuilt Post by: lukasdeopalenica on December 03, 2012, 12:02:25 PM Hi Guys,
After rebuilt of my brake system (new hoses, new seals at calipers and master cylinder) my brakes literally do not work at all. I tried to bleed the system, but it seems that the pump can not built the pressure and does not suck the fluid from the reservoir. Eventually I filled the hoses and calipers gravitically, just opened subsequently bleeding screws and waited for the fluid to come, and came at all points. Should the MC be bled additionally? I am almost sure, but not sure of course I have reassembled the MC correctly... I would be grateful for any tips :) Title: Re: No pressure after MC rebuilt Post by: lukasdeopalenica on December 04, 2012, 10:38:22 PM No one knows? :-\
Title: Re: No pressure after MC rebuilt Post by: MattNoVAT on December 05, 2012, 09:20:51 AM As you have filled the system with fluid then I would start by checking the master cylinder first to ensure that it has been rebuilt correctly.
Title: Re: No pressure after MC rebuilt Post by: thecolonel on December 05, 2012, 11:18:33 AM Dry rebuilds can cause the seals to flip over
the first time the pedal is pressed. Pain in the butt, but does happen I'm afraid. Title: Re: No pressure after MC rebuilt Post by: lukasdeopalenica on December 05, 2012, 03:56:32 PM It sounds like that. Thank you. So I will disassemble the mc once again...I hope the seals are still in working condition ;)
|