Lancia Beta Forum
October 31, 2024, 11:52:53 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: Looking for Lancia Beta parts: www.lanciabetaparts.co.uk
 
   Home   Help Contact Admin Search Calendar Gallery Articles Login Register  
Pages: [1]
  Print  
Author Topic: Setting toe in to take it for alignment.  (Read 3450 times)
0 Members and 1 Guest are viewing this topic.
dougdee123
Full Member
***
Offline Offline

United Kingdom United Kingdom

Posts: 96



« on: July 08, 2012, 11:50:38 AM »

I have been fighting with fitting a replacement rack and now want to set up the steering approximately before I take it to be aligned properly.

However I see from the Haynes Manual table of torques and settings that the toe in should be about 3.5mm. Does anyone know where this is measured? On the rim? On the disc? Some other place?

The reason I ask is that I have a laser range finder (used for surveying) that is accurate to millimetres so I could measure if I can find out more detail of the datum.

Or shall I just scrub the tyres down to Kwik Fit or Euromaster?

Doug
Logged
MattNoVAT
Administrator
Legendary Member
******
Offline Offline

France France

Posts: 1830



« Reply #1 on: July 08, 2012, 02:20:42 PM »

Doug,

I've only even seen the rims of the alloys used for setting toe.

When I did it last time I admit I did it mostly by eye and then drove the 5 - 6 miles to the nearest tyre fitting place who had all the right kit.... it didn't seem to harm the new boots.
Logged

1981 2000 Coupe S2/FL
1976 1600 Coupe S1
2007 Ypsilon 1.3 Bi-Colori
dougdee123
Full Member
***
Offline Offline

United Kingdom United Kingdom

Posts: 96



« Reply #2 on: July 08, 2012, 02:39:18 PM »

Hi Matt,

I'll probably do the same. Thanks for the input.

Doug
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines
SMFAds for Free Forums
Valid XHTML 1.0! Valid CSS!